The non-closing of the hook is one of the common faults of the laser cutting machine. Its appearance has seriously affected the cutting quality and efficiency of the laser cutting machine. It is mainly caused by the following six reasons:
First, measuring whether the laser cutting machine beam is parallel, under normal circumstances, the left and right deviation should not be more than 2MM, adjust the beam eccentric wheel to change the beam parallelism, so that the error reaches the required range.
Second, check whether the laser cutter car belt and beam belt are loose, whether the two sides of the belt Zhangjinchengdu is the same, adjust the belt Zhangjinchengdu, not too different on both sides.
Third, first disconnect the motor line of the car and the beam, push and pull the car and the beam smooth.
Fourth, check whether the beam support wheel on both sides of the laser cutter is damaged or has resistance, and whether the support wheel is damaged.
Fifth, under the boot state of the laser cutting machine, use the hand to push and pull the car and the beam, move the small front slightly up and down to see if there is a mechanical gap, tighten the synchronous wheel on the transmission shaft, and the car gap is too large to change the slider.
Sixth, see if the original graphics have errors, such as the graphics are crossed, not closed, lack of strokes, etc., correct the errors in the graphics before output the test.
- Router Systems
- The Difference Between Low-and High-end Routers
- Industrial Network Router Processing Module And...
- Industrial 4G Router RIPv2 New Features
- Option Industrial 4G Router
- Advanced Industry-grade Router Filter
- Fiber Laser Cutting Machine Characteristic
- Fiber Laser Cutting Machine Is Widely Used By K...
- Fiber Laser Cutting Machines Create Interest-dr...
- CNC Plasma Cutting Machines In The Importance O...
- How To Maintain Woodworking Carver Daily
- Three Different Ways To Drop Knife Of Furniture...
- How To Lift The Limit Alarm On The Woodworking ...